222
Figure 18 Selecting device class
e. On the Auto Deploy Configuration page, click OK.
A success message is displayed, as shown in Figure 19.
Figure 19 Deployment task
f. Add a deployment task for devices in equipment room B in the same way you add the
deployment task for the devices in equipment room A.
Configuring the DHCP server
In this example, an HPE device is operating as the DHCP server.
1. Configure an IP address pool to assign IP addresses and DNS server address to the CPEs.
This example uses subnet 10.185.10.0/24 for IP address assignment.
# Enable DHCP.
<DHCP_server> system-view
[DHCP_server] dhcp enable
To Next Page
Loading...
