71
calculate-password
command.
3.
(Optional.) Configure the
system contact.
snmp-agent sys-info
contact
sys-contact
By default, the system contact is
Hewlett Packard Enterprise
Company 3000 Hanover St
Palo Alto, CA94304
4. (Op
system location.
snmp-agent sys-info
location
sys-location
By default, the system location is
not configured.
5. Enable SNMPv3.
• In non-FIPS mode:
snmp-agent sys-info
version { all | { v1 | v2c |
v3 }* }
• In FIPS mode:
snmp-agent sys-info
version { all | { v1 | v2c |
v3 }* }
By default, SNMPv3 is used.
6. (Optional.) Change the local
engine ID.
snmp-agent local-engineid
engineid
By default, the local engine ID is
the company ID plus the device
ID.
IMPORTANT:
After you change the local
engine ID, the existing SNMPv3
users and encrypted keys
become invalid, and you must
reconfigure them.
7.
remote engine ID.
snmp-agent
remote
{ ip-address |
ipv6
ipv6-address }
[
vpn-instance
vpn-instance-name ]
engineid
engineid
By default, no remote engine ID
is configured.
To send informs to an SNMPv3
NMS, you must configure the
SNMP engine ID of the NMS.
8. (Optional.) Create or update a
MIB view.
snmp-agent mib-view
{
excluded
|
included
}
view-name oid-tree [
mask
mask-value ]
ViewDefault
this view, all the MIB objects in
the
iso
snmpUsmMIB
,
snmpVacmMIB
snmpModules.18
subtrees are
accessible.
Each view-name oid-tree pair
represents a view record. If you
specify the same record with
different MIB sub-
multiple times, the most recent
configuration takes effect.
Except for the four sub-trees in
the default MIB view, you can
create up to 16 unique MIB view
records.
9.
SNMPv3 group.
• In non-FIPS mode:
snmp-agent group v3
group-name [ authentication
| privacy ] [ read-view
view-name ] [ write-view
view-name ] [ notify-view
view-name ] [ acl acl-number
| acl ipv6 ipv6-acl-number ] *
By default, no SNMP group
exists.
To Next Page
Loading...
Need help?
General