To Next Page

To Previous Page

7. To remove the SATA/SAS re-driver card or SATA/USB converter card, loosen

the thumbscrews 1. Slide the card out of the rear of the Slim tray 2.

8. Locate the new Slim Drive Tray.

9. To install the SATA/SAS re-driver card or SATA/USB converter card, align the

card slides with the slots on the rear of the slim drive tray. Slide the card into

position in the rear of the Slim tray 1. Tighten the thumbscrews 2. Repeat

this step if there is a second card.

ROLSOS841-0

Figure 88. Remove the SATA/SAS re-driver card or SATA/USB converter card.

ROLSOS842-0

Figure 89. Install the SATA/SAS re-driver card or SATA/USB converter card

Chapter 11. Installation and Removal Procedures 165

Other manuals for IBM 7226

Questions and Answers:

Need help?

Do you have a question about the IBM 7226 and is the answer not in the manual?

General