IMBA-8650 Motherboard
Page 96
socket pins are properly inserted into the socket. See Figure 5-4. Step 0:
Figure 5-4: CF Card Installation
5.4 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper.
Figure 5-5: Jumper Locations
To Next Page
Loading...
Need help?
General
