IMBA-8650 Motherboard
Page 126
Channel 1 Slave
Channel 2 Master
Channel 3 Master
None
If no drives are connected to the IDE channel select this
option. Once set, this IDE channel becomes
inaccessible and any drives attached to it are
undetected.
Auto
(Default) Setting this option allows the device to be automatically
detected by the BIOS.
Manual
Selecting this option allows manual configuration of the
device on the IDE channel in BIOS.
Access Mode [Auto]
The Access Mode option can only be configured if the BIOS configuration option is set to
either Manual or Auto. Use the Access Mode option to determine the hard disk BIOS
translation modes. Most systems now use hard drives with large capacities and therefore
either the LBA translation mode or auto mode should be selected.
CHS
Select this mode if the HDD capacity is less than
504MB.
LBA
Select this mode if the HDD capacity is more than
8.4GB.
Large
This mode is an extended ECHS mode and while it
supports HDDs larger than 504MB, it is not
recommended.
Auto
(Default) If you are unsure of what access mode to set, select this
option.
To Next Page
Loading...
Need help?
General
