IMBA-8650 Motherboard
Page 147
IR Transmission Delay [Enabled]
Use the IR Transmission Delay option to specify whether or not there should be a delay
for the IR transmission.
Enabled
(Default) There is a transmission delay.
Disabled
There is no transmission delay.
UR2 Duplex Mode [Normal]
Use the Parallel Port Mode option to select parallel port operation mode.
Half
Default Half-duplex mode allows transmission in one direction
at a time only.
Full
Full-duplex mode allows transmission in both directions
at the same time.
Use IR Pins [IR-Rx2Tx2]
Use the Use IR Pins option to select which pins should be used for infrared.
IR-Rx2Tx2 (Default)
RxD2,TxD2
Onboard Parallel Port [378/IRQ7]
Use the Onboard Parallel Port option to select the parallel port base address.
Disabled
No base address is assigned to the Parallel Port
378/IRQ7 DEFAULT
Parallel Port I/O port address is 378 and the interrupt
address is IRQ7
278/IRQ5
Parallel Port I/O port address is 278 and the interrupt
address is IRQ5
To Next Page
Loading...
Need help?
General
