IMBA-8650 Motherboard
Page 155
PNP OS Installed [No]
Use the PNP OS Installed option to specify whether or not the operating system has plug
and play capablity.
No DEFAULT
The system OS does not support PnP and the BIOS must
configure non-boot devices
Yes
The system OS is PnP capable
Reset Configuration Data [Disabled]
Use the Reset Configuration Data option to reset the Extended System Configuration
Data (ESCD) when exiting setup if booting problems occur after a new add-on is installed.
Disabled DEFAULT
ESCD will not be reconfigured
Enabled
ESCD will be reconfigured after you exit setup
Resources Controlled By [Auto (ESCD)]
Use the Resources Controlled By option to either manually configure all the boot and
plug and play devices, or allow BIOS to configure these devices automatically. If BIOS is
allowed to configure the devices automatically IRQs, DMA and memory base address
fields cannot be set manually.
Auto(ESCD)
(Default) BIOS automatically configures plug and play devices as
well as boot devices.
Manual
Manually configure the plug and play devices and any
other boot devices.
IRQ Resources [Press Enter]
The IRQ Resources option (
BIOS Menu 13) can only be selected if the Resources
Controlled By option is set to Manual.
To Next Page
Loading...
Need help?
General
