IFM O3M150 - Page 101

101
ifm Vision Assistant O3M
UK
Colour mode [Logic output]
In the colour mode [Logic output] the colour changes in relation to the
condition of the virtual digital outputs of the ROI groups.
When using the standard logic of the device, the virtual output
with the number of the ROI group is used.
► Ensure that the numbering of the virtual outputs is correct if a
logic is used that you have defined yourself.
In the image on the left, the outputs of 24 ROI groups are shown as
logic output.
[Logic output] is set to "colour mode".
The "reference value" is set to [Z].
The "reference value" defines with which ROI group output the "moving
reference line" shifts. The following reference values can be selected:
● [X] - The "moving reference line" is projected in the Y-Z level and
moves with the reference value X.
● [Y] - The projection on the floor is projected in the X-Z level and
moves with the reference value Y.
● [Z] - The projection on the floor is projected in the Y-X level and
moves with the reference value Z.
The reference value additionally defines which provision of the ROI
group is used as basis for the projection on the floor.
The colour fields "Color when output=off" and "Color when output=on"
determine how the projection on the floor is visualised for the 2
possible conditions.
The "moving reference line" shows the output of the ROI groups
graphically as a line in the projection on the floor. The "moving
reference line" can be set:
● By activating the control field, the "moving reference line" is shown.
● By clicking on the colour field, the colour of the "moving reference
line" can be changed.