Revision 0.9
1
1.0 Introduction
1.1 Objective
The objective of this document is to define a SGRAM specification (“PC SGRAM”). It should be
easy to design and manufacture and highly cost optimized for the main stream volume desktop
Graphics architecture PCs.
1.2 Scope of This Document
The scope of this document is limited to identify and define all the essential functionality that is
needed to be implemented for “PC SGRAM”. Implementation details are left to the designers of
the device.
1.3 Convention Used
•
# sign after signals are used after the signal names for active low signals (e.g., CS#, RAS#,
etc.)
To Next Page
Loading...
Need help?
General