Using the Terminal Emulation Menus—Chapter 4
109TE 2000
5250 Terminal Emulation Programmer’s Guide
2) RTC/WTP (6400, 5055, 59XX, 17XX, 11XX)
Use 2) RTC/WTP to set, view, or change the terminal ID. This number
allows the host computer to identify individu al terminals in the radio data
network. Each terminal must have a unique number in the same network.
The 1) Radio Setup and 2) Host/Cntl menusareshownonthefollowing
pages. Pending on which option you are exer cising you will e ither advance
to the WTP Stack settings or the TCP/IP Stack settings.
WTP Settings
Use the numeric keys on the terminal keyboard or 5055 external keyboard
to modify its ID. Enter a number between 0–126, then press [Enter] to go
to the 2) Host/Cntl menus.
The LAN ID number can be 0–255 depending on the radio being used.
With the RM60/70 radio, the nu mber can be 0–255; with the RM80/90
radio, the range is 0–15. Y our terminal only communicates w ith equip-
ment using the same ID number that you assigned to your LAN.
If you enter a LAN ID number different from what is configured in the
NET.CFG file you get the following message. If this happens, the system
modifies NET.CFG, which is used by WTPPKT.EXE on initializing the
terminal.
LAN ID changed
Need to reboot
to take effect.
To Next Page
Loading...
