Intermec CK30

Using the Terminal Emulation MenusChapter —4
110 TE 2000
 5250 Terminal Emulation Programmer’s Guide
For 802.11 Radios Only
Host/Cntl
1) Radio Setup
2) Host/Cntl
Radio Setup
Network Name
xxxx
Enter up to 34 char -
acters for a name
Radio Setup
LAN
xx
Radio Setup
Radio Config#
Set Mode/Channel
Use Cursor Up
and Down Keys
To Adjust
DS xxxx
channel xx
ENTER
ENTER (5055 -- continue to Host/Cntl setups)
For Non 802.11 Radios
Set Frequency
Use Cursor Up
and Down Keys
To Adjust
xxxxxxxxx
ENTER (continue to Host/Cntl setups)
Go to Host/Cntl on the
next page
Only if a “radio cfg“ file is present on the terminal.
[1] [2]
[2]
Controller Type
1)
2) RTC/WTP
3)
Set Frequency is for
Synthesized UHF radio
s
WTP Stack Options
Set Mode/Channel
is for RM60
(902 MHz) radios