Intermec CK30

Using the Terminal Emulation MenusChapter —4
112 TE 2000
 5250 Terminal Emulation Programmer’s Guide
When designating additional h osts f or the 6400 Computer or 5055 PC,
you must:
S Tell the 6400 Computer or 5055 PC the host type of e ach host com-
puter: (3270, 5250, or VT/ANSI).
S Tell the 6400 Computer or 5055 PC the name of each h ost.
Note: Selections in these menus apply only to the current session. Use
4) Session Menu to verify or change the current session.
Direct
1) Radio Setup
2) Host Setup
Radio Setup
Radio Config#
Set Mode/Channel
Use Cursor Up
and Down Keys
To Adjust
DS xxxx
channel xx
ENTER (5055 -- continue to Host/Cntl setups)
Only if a “radio cfg“ file is
present on the terminal.
Set Frequency
Use Cursor Up
and Down Keys
To Adjust
xxxxxxxxx
ENTER (continue to Host/Cntl setups)
Host
1) Host A
2) Host B
3) Host C
ENTER
Host Name (x)
Host emulation
Host Name
Enter up to 64 char -
acter/numbers for a
name
ENTER
Emulation (x)
1)
2) 3270
3) 5250
4) VT/ANSI
[1] [2]
For 802.11 Radios Only
Radio Setup
Network Name
xxxx
Enter up to 34 char -
acters for a name
Radio Setup
LAN
xx
ENTER
For Non 802.11 Radios
TCP/IP Stack Options
Set Frequency is for
Synthesized UHF
radios
Set Mode/Channel
is for RM60
(902 MHz) radios