Intermec CK30

Using the Terminal Emulation Menus—Chapter 4
113TE 2000
 5250 Terminal Emulation Programmer’s Guide
3) Direct Connect (2415, 2425, 2435A, 2455, 2475, 248X, 5020, 700 Series, CK30,
CK31, CV60 with TE/IP)
To set these options, select 3) Direct Connect > 2) Host Setup > 1) Host
A.UsetheEmulation (A) option to tell the terminal the type of each host
compu ter. Default is 3270.
Note: You can also set the emulation type through the 2) Data Stream
option on the 3) Protocol Opts menu.
Direct Connect
1)
2) Host Setup
[3]
Controller Type
1)
2)
3) Direct Connect
[2]
2) Host B and
3) Host C are for
5020, 700 Series, CK30, CK31, CV60
Host
1) Host A
2) Host B
3) Host C
ENTER
Host Name (x)
Host emulation
Unit # xxx
Host Name
Enter up to 64 char -
acter/numbers for a
name
ENTER
Emulation<A, B, or C>
1) Native
2) 3270
3) 5250
4) VT/ANSI
Port Number (x)
23
If you want to use a port other than 23,
enter that port here. Range is 0–65535.
ENTER
Unit # xxx is for 700 Series, CK30, CK31, CV60
and appears if RTC over TCP is enabled.
Emulation<A, B, or C>
1) RTC over TCP
Emulation<A, B, or C>
Enter Unit
Number:
xxx
ENTER
These two boxes are for
700 Series, CK30, CK31, CV60
Note: If the Native protocol is selected,
RTC over TCP cannot be disabled.
ENTER