Intermec CK30

Using the Terminal Emulation Menus—Chapter 4
117TE 2000
 5250 Terminal Emulation Programmer’s Guide
S 2) Scan PreChar and 3) Scan PostChar
Enter a hexadecimal value from 00–FF for the character to be sent pre-
ceding the scanned data or after the scanned data. The value of 20h
means that pre- or post-characters are not sent.
S 4) ParmsBySession (5020, 700 Series, CK30, CK31, CV60)
When enabled, the symbology parameters under 1) Set-up Parms >
2) Barcode Parms configure Windows CE terminal scanning devices on
a per-session basis.
When disabled (default),the2) Barcode Parms option is ignored. The
TE 2000 application does not conf igu re symbology parameters for Win-
dows CE terminal scanning devices. The settings selected via the Win-
dows CE System Data Collection applet are used for both TE 2000 ses-
sions. You can configure the symbology parameters under 1) Set-up
Parms > 2) Barcode Parms , however these are not used.
S 5) Use Wedge Mode (700 Series, CK30, CK31, CV60)
This cau ses the TE 2000 application to use the system Scanners and
Symbologies settings. All scanned data will come into the TE 2000 ap-
plication from the system Virtual Wedge per the Virtual Wedge settings
as if the scanned bar code characters were typed into the keyboard.
When Use Wedge Mode is enabled, none of the TE 2000 menu options
for scanning will function, such as the following:
S Auto Tab Scan, Aut Entr Scn, BRT Auto Enter, ANY Auto Enter,
Scan PreChar, Scan PostChar, symbology enable, disable, mix-max or
fixed lengths, drop leading, or trailing characters.
Scanner data will not be inhibited when in a non-scannable field in TE
2000 3270 or TE 2000 5250.
When Use Wedge Mode is enabled, all of the system Scanners and
Symbologies capabilities will be available. This means that all of the
symbology options and grid options for special edits can be used.
Use Wedge Mode can be enabled in TE_SETTINGS.INI by session
but only the setting for Session 1 will be used. The Session 1 setting will
be propogated across all sessions. If you enable Use Wedge Mode in TE
2000 menus and then save the parameters, you will see the
TE_SETTINGS.INI contains the same Use Wedge Mode value for all
sessions.
Scan Options
1) Scan Timeout
2) Scan PreChar
3) Scan PostChar
4) ParmsBySession
5) Use Wedge Mode
1) Scan Timeout is for 59XX, 17XX, 11XX
4) ParmsBySession is for 5020, 700 Se-
ries, CK30, CK31, CV60
5) Use Wedge Mode is for 700 Series,
CK30, CK31, CV60