Intermec CK30 - Page 152

Using the Terminal Emulation MenusChapter —4
128 TE 2000
 5250 Terminal Emulation Programmer’s Guide
4) Auto Tab Scan
Causes the terminal to automatically tab to the next input field when a
good scan is obtained. Default is disabled.
Note: 4) Auto Tab Scan cannotbeenabledatthesametimeas3) Auto
Entr Scan.
5) Local Echo
Allows characters to be displayed from terminal memory but not from host
memory. Default is disabled.
6) AnswerBack
Enables you to enter a character string that is sent to the host in response
to an inquiry (hex adecimal 05). The range is 0–30. Default is null string for
2415, 2425, 2435A, 24 55, 24 75, 248X, 64 00, 5020, 5055, 59XX, 17XX,
11XX T erminals and the terminal’s serial number for 700 Series, CK30,
CK31, CV60 Terminals.
AnswerBack
Message
If you enter any of the following control characters, it is sent out. Note that
control strings count as one character.
<ACK> <DC2> <EOT> <GS> <SI> <US>
<BEL> <DC3> <ESC> <HT> <SO> <VT>
<BS> <DC4> <ETB> <LF> <SO H>
<CAN> <DLE> <ETC> <NAK> <STX>
<CR> <EM> <FF> <NUL> < SUB>
<DC1> <ENQ> <FS> <RS> <SYN>
7) More
Calls up the following VT/ANSI More Options screen.
VT/ANSI More Options
1) Screen Lock
2) DiscreteBells
3) UserKey Locked
4) RS232 Setup
5) VT220 Mode
6) Lock Mode
7) More
2) DiscreteBells is for 6400,
5055, 5020, 59XX, 17XX, 11XX
4) RS232 Setup is for 6400,
5020, 5055, 59XX, 17XX, 11XX,
700 Series, CK30, CK31, CV60
S 1) Screen Lock
Sets and locks the screen to a specified size. Any characters outside this
screen size are ignored by the hand-held unit. Default is disabled.