Using the Terminal Emulation Menus—Chapter 4
127TE 2000
5250 Terminal Emulation Programmer’s Guide
S 4) Any Auto Enter
When enabled, an automatic “enter” occurs when a reverse video attrib-
ute field is filled by keying or scanning data. Any extra scanned data is
discarded. If disabled, the screen waits for the user to hit the AID key
prior to sending data back to the host. Default is disabled.
3270
1) Device Name
2) Allow NAWS
3) BRT Auto Enter
4) Any Auto Enter
3270
1) Keybrd Unlock
2) Auto Tab Scan
3) Auto Entr Scn
4) Emulate 3210
5) Telnet
6) Origin Set
7) More
[7]
4) Emulate 3210 is for
6400, 5055, 59XX, 17XX, 11XX
5) Telnet is blank for
5020, 700 Series, CK30, CK31, CV60
6) VT/ANSI
The 6) VT/ANSI menu enables the following features if the VT/ANSI
communication protocol is used.
VT/ANSI
1) DEL To BS
2) CR To CRLF
3) Auto Entr Scn
4) Auto Tab Scan
5) Local Echo
6) AnswerBack
7) More
1) DEL to BS (Delete to Backspace)
Causes the [CLEAR] key to delete the character to the left of the cursor
position, and moves the cursor back one space. When this option is not
enabled, the [CLEAR] key deletes the character at the cursors position.
Default is disabled.
2) CR to CRLF (Carriage Return to Carriage Return/Line Feed)
Causes <Enter> to perform a carriage return and a line f eed. When this
option is not enabled, <Enter> performs a carriage return only. Default is
disabled.
3) Auto Entr Scn (Auto Enter Scan)
Actuates the <Enter> fu nction whenever a good scan is obtained. Default is
enabled for version 6.60 or greater, otherwise the default is disabled.
Note: 3) Auto Entr Scn cannotbeenabledatthesametimeas4) Auto
Tab Scan.
To Next Page
Loading...
