Using the Terminal Emulation Menus—Chapter 4
131TE 2000
5250 Terminal Emulation Programmer’s Guide
S 2) Term Setup
Selects the compliance level of the terminal being emulated. Default is
VT340 to support all commands. Make a selection, then press [Enter]
to return to the 3) Protocol Opts menu.
Term Setup
1) ANSI
2) VT100
3) VT220
4) VT320
5) VT340
6) IBM 330X
S 3) Send XON
Default is enabled which indicates that when an RIS is r eceived from
the host, the XON character is returned after compliance of this
command. Default is enabled.
S 4) Keypad Mode
Determines what is returned to the host when keys are pressed.
Default is 2) Numeric.
S 1) Application
Generates application ESC sequences for the key code. For help,
refertoyourVTmanual.
S 2) Numeric
Generates ANSI cursor control ESC sequences that correspond to
what appears on the face of the keys.
Keypad Mode
1) Application
2) Numeric
To Next Page
Loading...
