Intermec CK30

Using the Terminal Emulation MenusChapter —4
158 TE 2000
 5250 Terminal Emulation Programmer’s Guide
In the Current Items box on the right, are the set toolbar values. The
items you can include in the toolbar are listed under Available Items on
the left.left hand side is the available items that you can add to the toolbar.
To select an item, tap that item, then tap the appropriate >> or << buttons
to move the item to the other box.
To rearrange the order that items are displayed in the toolbar, select an
item fr om the Current Items list, then use the Up or Dn buttons to move
the selected item up or down the list of items shown in the toolbar.
As you select an item, Item Width shows the default width value and the
current row width is recalculated. On 700 Series and CK31 Terminals, the
maximum toolbar width is 240 pixels. On a CV60 Terminal, the maxi-
mum toolbar width is 800 pixels.
Note: We do not test for the maximum width of terminal displays. If the
toolbar exceeds the maximum width of your display, then the items in the
toolbar that go past the maximum width are not shown and the data that
is not visible is not checked for errors.
Under Available Items:
S Select “Host IP” to display the current IP address of the host or DNS
name for the host in the toolbar.
S Select “Power Indicator” to display (in a graphical form) the percentage
of the battery life still available in the toolbar. Below is a color chart:
Color Percentage of Available Battery Life
Green Above 66%
Yellow Between 33% and 66%
Red Below 33%
Brown Unknown