PLDC01938
REVISION 00
01/06/2011
TECHNICAL DEPT
Stavale
- date 05/09/2011
156/195
11
First remove the centring coupling A5, then continue screwing up the screws B until you can extract the
rubber tyred ring A4.
12
Replace the rubber tyred ring with a new one.
Reassembly
1
To mount the new rubber tyred ring, perform the disassembly operations in reverse.
2
Clean the contact surface of the drive hub A8 with the four (4) threaded holes and the contact surface of the
centring coupling A5.
3
Clean the six (6) screws A3 and apply thread lock to the first threads before screwing up.
4
Premount the centring coupling A5 to the rubber tyred ring A4 using the screws A3, tighten with moderation
using a maximum torque of 7 - 8 Nm (~ 0.7 - 0.8 kgm)
A4
A5
PHOTO 324
A8
A5
PHOTO 325
To Next Page
Loading...
