ITech IT6400 Series - Scope:runstop <Bool; Scope:auto; Scope:show

Scope commands
Copyright © Itech Electronic Co., Ltd. 92
Query syntax
SCOPe:TIME:BASE?
Returns
<NRF>
SCOPe:RUNStop <bool>
This command sets to start or stop the oscilloscope function.
Command syntax
SCOPe:RUNStop <bool>
Arguments
ON/OFF/0/1
Example
SCOP:RUNS 1
Query syntax
SCOPe: RUNStop?
Returns
0/1
SCOPe:AUTO
This command sets the oscilloscope function under automatic adaption mode.
Command syntax
SCOPe:AUTO
Arguments
NONE
SCOPe:SHOW
This command sets the parameter display ON/OFF of oscilloscope function.
The parameter 3Bit indicates DAU.
If parameter is 7, 111 is displayed, indicating that all is ON; if parameter is 6,
110 is displayed, indicating that voltage display is off and current and digital
voltmeter display is ON.