ITech IT6400 Series Programming Guide

Trigger commands
Copyright © Itech Electronic Co., Ltd. 81
Example
TRIG:SEQ2:SLOP:CURR POS
Query syntax
TRIGger:SEQuence2:SLOPe:CURRent?
TRIGger:ACQuire:SLOPe:CURRent?
Returns
<CRD>
Related Command
TRIG:SEQ2:SLOP:VOLT
TRIGger:SEQuence2:SLOPe:DVM
TRIGger:ACQuire:SLOPe:DVM
This command sets the slope of the DVM input signal.
POSitive measurement triggering occurs on the rising edge.
NEGative measurement triggering occurs on the falling edge.
EITHer measurement triggering occurs on either edge.
Command syntax
TRIGger:SEQuence2:SLOPe:DVM<slope>
TRIGger:ACQuire:SLOPe:DVM<slope>
Arguments
EITHer | POSitive | NEGative
RSTValue：
POSitive
Example
TRIG:SEQ2:SLOP:DVM POS
Query syntax
TRIGger:SEQuence2:SLOPe:DVM?
TRIGger:ACQuire:SLOPe:DVM?

ITech IT6400 Series Specifications

General

Brand	ITech
Model	IT6400 Series
Category	Power Supply
Language	English