Status commands
Copyright © Itech Electronic Co., Ltd. 23
Arguments
None
Example
STAT:QUES:COND?
Returns
<NR1> (register value)
Related Command
STAT:OPER:COND?
STATus:OPERation?
This query returns the value of the Operation Event register. The Event register
is a read-only register that holds (latches) all events that are passed by the
Operation NTR and/or PTR filter. Reading the Operation Event register clears it.
This command is not channel specific, it applies to the entire mainframe.
Query syntax
STATus:OPERation[:EVENt]?
Arguments
None
Example
STAT:OPER:EVEN?
Returns
<NR1> (register value)
Related Command
*CLS
STATus:OPERation:ENABle
This command and its query set and read the value of the Operation Enable
register. This register is a mask for enabling specific bits from the Operation
Event register to set the operation summary bit (OPER) of the Status Byte
register. The operation summary bit is the logical OR of all enabled Operation
Event register bits. This command is not channel specific, it applies to the entire
To Next Page
Loading...
Need help?
General
