ITech IT6400 Series - [Source:]Voltage:trigger

Output command
Copyright © Itech Electronic Co., Ltd. 70
Example
VOLT:PROT:STAT 1
Query syntax
[SOURce:]VOLTage:PROTection:STATe?
Returns
0|1
[SOURce:]VOLTage:TRIGger
This command sets a preset voltage value for source. This preset value will be
promptly transferred to output if a trigger is generated. To generate trigger, the
trigger subsystem must be initialized (in trigger subsystem, INITiate command
is used for initialize trigger).
Command syntax
[SOURce:]VOLTage[:LEVel]:TRIGgered[:AMPLitude]
Arguments
<NRf+>
Unit
V (volts)
RST Value
0
Example
VOLT:TRIG 15 VOLTAGE:LEVEL:TRIGGERED 15
Query syntax
[SOURce:]VOLTage[:LEVel]:TRIGgered[:AMPLitude]?
Returns
<NR3>
Related Command
VOLT VOLT:PROT