ITech IT6400 Series Programming Guide

IEEE-488 Commands
Copyright © Itech Electronic Co., Ltd. 12
query
Register.
*STB?
Read status byte query
Reads the Status Byte Register.
*TRG
Trigger Command
Send a trigger to Power supply.
*TST?
Self-test query
Perform selftest, then return result.
*WAI
Wait to continue
command
Wait until all previous commands are
executed.
*CLS — Clear Status
This command clears the bits of the following registers:
 Standard Event Register
 Operation Event Register
 Questionable Event Register
 Error Queue
Command syntax
*CLS
Arguments
None
*ESE <NRf> — Event Enable
This command programs the Standard Event Status Enable register bits. The
programming determines which events of the Standard Event Status Event
register (see *ESR?) are allowed to set the ESB (Event Summary Bit) of the
Status Byte register. A "1" in the bit position enables the corresponding event.
All of the enabled events of the Standard Event Status Event Register are
logically ORed to cause the Event Summary Bit (ESB) of the Status Byte
Register to be set.
Command syntax
*ESE <NRf>
Arguments
0 to 255
Default Value
see *PSC

ITech IT6400 Series Specifications

General

Brand	ITech
Model	IT6400 Series
Category	Power Supply
Language	English