ITech IT6400 Series - Rst; Sav; Sre

IEEE-488 Commands
Copyright © Itech Electronic Co., Ltd. 16
Related Command
*PSC *RST *SAV
*RST
This command resets ALL channels of the power supply to the following
factory-defined states.
Command syntax
*RST
Arguments
None
*SAV
This command stores the present state of the power supply to a specified
location in memory. Up to 100 states can be stored. If a particular state is
desired at power-on, it should be stored in location 0. It then will be recalled at
power-on if the power-on state is set to RCL0. Use *RCL to retrieve instrument
states.
NOTE:*SAV does not save the programmed trigger values
([SOURce:]CURRent:TRIGGer, [SOURce:]RESistance:TRIGGer,
[SOURce:]VOLTage:TRIGGer). Programming an *RCL, or a *RST command
causes the triggered settings to revert to their [IMMediate] settings.
Command syntax
*SAV <NRf>
Arguments
0 to 49
Example
*SAV 3
Related Command
*PSC *RST *RCL
*SRE
This command sets the condition of the Service Request Enable Register. This