Status commands
Copyright © Itech Electronic Co., Ltd. 20
Chapter3 Status commands
STATus Subsystem, These commands program the power supply status
registers.
STATus:QUEStionable?
This query returns the value of the Questionable Event register. The Event
register is a read-only register that holds (latches) all events that pass into it.
Reading the Questionable Event register clears it. This command is not
channel specific, it applies to the entire mainframe.
Command syntax
STATus:QUEStionable[:EVENt]?
Arguments
None
Example
STAT:QUES:EVEN?
Returns
<NR1> (register value)
Related Command
*CLS
STATus:QUEStionable:ENABle
This command sets or reads the value of the Questionable Enable register.
This register is a mask for enabling specific bits from the Questionable Event
register to set the questionable summary (QUES) bit of the Status Byte
register.This bit (bit 3) is the logical OR of all the Questionable Event register
bits that are enabled by the Questionable Status Enable register. This
command is not channel specific, it applies to the entire mainframe.
Command syntax
STATus:QUEStionable:ENABle <NR1>
To Next Page
Loading...
Need help?
General
