ITech IT6400 Series - Trigger:sequence2:Slope:voltage; Trigger:acquire:slope:voltage

Trigger commands
Copyright © Itech Electronic Co., Ltd. 82
Returns
<CRD>
Related Command
TRIG:SEQ2:LEV:DVM
TRIGger:SEQuence2:SLOPe:VOLTage
TRIGger:ACQuire:SLOPe:VOLTage
This command sets the slope of an internally triggered voltage measurement.
POSitive triggering occurs on the rising edge.
NEGative triggering occurs on the falling edge.
EITHer triggering occurs on either edge.
Command syntax
TRIGger:SEQuence2:SLOPe:VOLTage<slope>
TRIGger:ACQuire:SLOPe:VOLTage<slope>
Arguments
EITHer | POSitive | NEGative
RSTValue：
POSitive
Example
TRIG:SEQ2:SLOP:VOLT POS
Query syntax
TRIGger:SEQuence2:SLOPe:VOLTage?
TRIGger:ACQuire:SLOPe:VOLTage?
Returns
<CRD>
Related Command
TRIG:SEQ2:SLOP:CURR