Measurement Commands
Copyright © Itech Electronic Co., Ltd. 45
returned by these queries.
Command syntax
MEASure[:SCALar]:VOLTage :HIGH?
FETCh[:SCALar]:VOLTage :HIGH?
Arguments
None
Example
MEAS: VOLT:HIGH?
FETC: VOLT:HIGH?
Returns
<NR3>
Related Command
MEAS: CURR:LOW?
MEASure:VOLTage:LOW?
FETCh:VOLTage:LOW?
These queries return the Low level voltage of a voltage pulse waveform. The
instrument first measures the minimum and maximum data points of the pulse
waveform. It then generates a histogram of the pulse waveform using 16 bins
between the maximum and minimum data points. The bin containing the most
data points below the 50% point is the low bin. The average of all the data
points in the low bin is returned as the Low level. If no low bin contains more
than 1.25% of the total number of acquired points, then the minimum value is
returned by these queries.
Command syntax
MEASure[:SCALar]:VOLTage :LOW?
FETCh[:SCALar]:VOLTage :LOW?
Arguments
None
To Next Page
Loading...
Need help?
General
