ITech IT6400 Series Programming Guide

Remote Control
Copyright © Itech Electronic Co., Ltd. 8
mode.
6 OVERLOAD The power supply has overload current and is set.
Standard Event Status Group
0 OPC Operation Complete. Operation of power supply is
completed.
1 This bit is not used.
2 QYE Query Error. Data of output array is missing.
3 DDE Device-Dependent Error. Data stored in register is
missing or error occurs in preliminary checkout.
4 EXE Execution Error. Order parameter overflows or the
condition is not right.
5 CME Command Error.Command syntax or semantic error
occurs when receiving information.
6 This bit is not used.
7 PON Power-On.It is 1 when power supply is reset.
Status Byte and Service Request Enable Registers
0-2 Bits 0-2 are not used.
3 QUES Questionable Status Summary. Indicates if an enabled
questionable event has occurred.
4 MAV Message Available Summary. Indicates if the Output
Queue contains data.
5 ESB Event Status Summary. Indicates if an enabled
standard event has occurred.
6 RQS/ MSS Master Status Summary.
Request Service.
7 OPER Operation Status Summary. Indicates if an operation
event has occurred.
Structure of condition register as following:

ITech IT6400 Series Specifications

General

Brand	ITech
Model	IT6400 Series
Category	Power Supply
Language	English