EasyManuals Logo

ITech IT6400 Series Programming Guide

ITech IT6400 Series
128 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
Remote Control
Copyright © Itech Electronic Co., Ltd. 10
The interface accepts MsgID = TRIGGER USBTMC command message
and forwards TRIGGER requests to the function layer.
The USB488device capabilities of the power are described below:
The device understands all mandatory SCPI commands.
The device is SR1 capable.
The device is RL1 capable.
The device is DT1 capable.
GPIB Interface
First connect GPIB port of power to GPIB card of PC with IEEE488 BUS. They
must be sufficient contact and tighten the screws. And then set address. The
address can be set from 1 to 30.
Select “Menu > System > Sys Com” to enter Communication Configuration
page. Select GPIB by pressing arrow keys, and then set the GPIB address,
press [OK] to confirm. The power operates from a GPIB address set from the
front panel. The GPIB address is stored in non-volatile memory.
LAN Interface
Select “Menu > System > Sys Com” to enter communication configuration
page. Select LAN by pressing arrow keys and then configure Gateway, IP,
Mask and Socket Port in the LAN option. Use a cross network cable through
LAN interface to connect PC.

Table of Contents

Other manuals for ITech IT6400 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ITech IT6400 Series and is the answer not in the manual?

ITech IT6400 Series Specifications

General IconGeneral
BrandITech
ModelIT6400 Series
CategoryPower Supply
LanguageEnglish

Related product manuals