[edit]
root@# set system backup-router address
11. Configure the IP address of a DNS server.
[edit]
root@# set system name-server address
12. Set the root authentication password by entering either a clear-text password, an
encrypted password, or an SSH public key string (DSA or RSA).
[edit]
root@# set system root-authentication plain-text-password
New password: password
Retype new password: password
or
[edit]
root@# set system root-authentication encrypted-password encrypted-password
or
[edit]
root@# set system root-authentication ssh-dsa public-key
or
[edit]
root@# set system root-authentication ssh-rsa public-key
13. (Optional) Configure the static routes to remote subnets with access to the
management port. Access to the management port is limited to the local subnet. To
access the management port from a remote subnet, you need to add a static route
to that subnet within the routing table. For more information about static routes, see
the Junos OS Administration Library.
[edit]
root@# set routing-options static route remote-subnet next-hop destination-IP retain
no-readvertise
14. Configure the telnet service at the [edit system services] hierarchy level.
[edit]
root@# set system services telnet
15. (Optional) Display the configuration to verify that it is correct.
[edit]
root@# show
system {
host-name host-name;
domain-name domain-name;
backup-router address;
root-authentication {
authentication-method (password | public-key);
103Copyright © 2017, Juniper Networks, Inc.
Chapter 17: Initially Configuring the MX5, MX10, MX40, and MX80 Routers
To Next Page
Loading...
