Keithley 2001

IEEE-488 Reference
4-180
Programming example 10 OUTPUT 716; “:stat:oper:enab 514; enab?”
20 ENTER 716; A$
30 PRINT A$
40 END
Line 10 Sets Bits B1 and B9 of the Operation Event Enable Register, and then queries the reg-
ister.
Line 20 Addresses the Model 2001 to talk.
Line 30 Displays the decimal value that defines which bits in the register are set (514).
4.21.3 :PTRansition <NRf>
:STATus:MEASurement:PTRansition <NRf> Program Measurement Transition Filter (PTR)
:STATus:QUEStionable:PTRansition <NRf> Program Questionable Transition Filter (PTR)
:STATus:OPERation:PTRansition <NRf> Program Operation Transition Filter (PTR)
:STATus:OPERation:TRIGger:PTRansition <NRf> Program Trigger Transition Filter (PTR)
:STATus:OPERation:ARM:PTRansition <NRf> Program Arm Transition Filter (PTR)
:STATus:OPERation:ARM:SEQuence:PTRansition <NRf> Program Sequence Transition Filter
(PTR)
Parameters <NRf> = 0 Clear PTR register
= 1 Set bit B0 of PTR registe
= 2 Set bit B1 of PTR register
= 4 Set bit B2 of PTR register
= 8 Set bit B3 of PTR register
= 16 Set bit B4 of PTR register
= 32 Set bit B5 of PTR register
= 64 Set bit B6 of PTR register
= 128 Set bit B7 of PTR register
= 256 Set bit B8 of PTR register
= 512 Set bit B9 of PTR register
= 1024 Set bit B10 of PTR register
= 2048 Set bit B11 of PTR register
= 16384 Set bit B14 of PTR register
Formats :stat:meas:ptr <NRf>
:stat:ques:ptr <NRf>
:stat:oper:ptr <NRf>
:stat:oper:trig:ptr <NRf>
:stat:oper:arm:ptr <NRf>
:stat:oper:arm:seq:ptr <NRf>
Defaults Power-up Sets (1) all bits
*CLS No effect
:STATus:PRESet Sets (1) all bits