Getting Started
2-14
:DELay?, :SOURce?, and :TIMer?). For example, the
:TRIGger:SOURce? query command is used to request the
presently selected control source. After the query command
is sent and the Model 2001 is addressed to talk, a message
identifying the selected control source will be sent to the
computer.
Table 2-6
Abbreviated common command summary
Mnemonic Name Description
*CLS Clear status Clears error queue, event registers, and IEEE-488 bus service request (SRQ) line.
*RCL <n> Recall Returns the instrument to the setup configuration stored in memory (n = 0 for
STD, n = 0 to 4 for MEM1, or n = 0 to 9 for MEM2).
*RST Reset Returns the Model 2001 to *RST default conditions (see Appendix B).
*SAV <n> Save Saves the present setup configuration in memory (n = 0 for STD, n = 0 to 4 for
MEM1, or n = 0 to 9 for MEM2).
*TRG Trigger Issues a bus trigger (same as group execute trigger command; GET).
2.6.6 Abbreviated SCPI command summary
Most instrument operations are controlled using SCPI com-
mands. Table 2-7 provides an abbreviated list of the SCPI
commands necessary to perform some basic operations.
Not shown in the table are companion query commands for
the :ARM and :TRIGger subsystem commands (:COUNt?,
To Next Page
Loading...
