Keithley 2001

J
SCPI Conformance Information
J-1
Introduction
The Model 2001 complies with SCPI version 1991.0. Table J-1 lists the SCPI confirmed commands implemented by the Model
2001, and Table J-2 lists the non-SCPI commands implemented.
Table J-1
Syntax of SCPI confirmed commands implemented by Model 2001
Command Description
:CALCulate[1]
:FORMat <name>
:FORMat?
:STATe <b>
:STATe?
:DATA?
:IMMediate
:CALCulate2
:FORMat <name>
:FORMat?
:STATe <b>
:STATe?
:IMMediate
:DATA?
:CALCulate3
:LIMit[1]
:UPPer
[:DATA] <n>
[:DATA]?
:SOURce <NRf>
:SOURce?
:LOWer
[:DATA] <n>
[:DATA]?
:SOURce <NRf>
:SOURce?
Subsystem to control CALC 1:
Select math format: MXB, PERCent, NONE.
Query math format.
Enable (1 or ON) or disable (0 or OFF) calculation.
Query state of math function.
Read math result of CALC 1.
Recalculate input data.
Subsystem to control CALC 2.
Select math format: MEAN, SDEViation, MAXimum, MINimum, PKPK, NONE.
Query math format.
Enable (1 or ON) or disable (0 or OFF) calculation.
Query state of math function.
Recalculate raw input data in buffer.
Read math result of CALC 2.
Subsystem to control CALC 3 (limit tests):
Path to control LIMIT 1 test:
Path to configure upper limit:
Specify upper limit (-9.99e35 to +9.99e35).
Query upper limit.
Specify digital output (0 to 15).
Query source.
Path to configure lower limit:
Specify lower limit (-9.99e35 to +9.99e35).
Query lower limit.
Specify digital output (0 to 15).
Query source.