G
Controller Programs
G-1
The following programs have been supplied as a simple aid
to the user and are not intended to suit specific needs. Each
program allows you to send a command message to the in-
strument and obtain and display a response from the instru-
ment for query commands.
Programs for the following controllers are included:
• A BASIC program for an IBM PC/XT/AT with a Capi-
tal Equipment Corporation PC<>488 Interface (Kei-
thley Model PC-488-CEC IEEE-488 Interface Card).
• A BASIC program for an IBM PC/XT/AT with IOtech
Driver488 Software.
• A BASIC program for a Hewlett-Packard Model 9000
Series 200/300 computer.
• A program written with the ASYST software package
(available from Keithley Instruments) for an IBM PC/
XT/AT with a Capital Equipment Corporation
PC<>488 Interface.
• A BASIC program for an IBM PC/XT/AT with a Na-
tional GPIB PC Interface.
To Next Page
Loading...
