N9030B PXA Signal Analyzer Service Guide 481
Assembly Replacement Procedures
RF Area (Options 544, 550)
Replacement
1. Refer to Figure 16-47. Place the switch onto the bracket and replace the
five screws (3) (0515-0372). Torque to 9 inch-pounds.
2. Place the switch/bracket into place into the chassis and replace the two
screws (0515-0372). Torque to 9 inch-pounds starting with the screw
closest to the front of the instrument.
3. Refer to Figure 16-45. Replace the semi-rigid cables W6, W8, and W56.
Torque to 10 inch-pounds.
4. Replace the ribbon cable W7. Ensure locking tabs on the sides of the
connector are engaged.
5. Refer to Figure 16-43. Position the RF bracket onto the chassis and
replace the sixteen screws (0515-0372). Torque to 9 inch-pounds.
6. Replace the front panel. Refer to the Front Frame Assembly replacement
procedure.
7. Replace the instrument outer case. Refer to the Instrument Outer Case
replacement procedure.
To Next Page
Loading...
Need help?
General
