Keysight DAQ970A User Guide

Safety and EMC Requirements
This instrument is designed to comply with the following safety and EMC requirements:
Safety compliance
l IEC 61010-1:2010/EN 61010-1:2010; IEC 61010-2-030:2010/EN61010-2-030:2010
l Canada: CAN/CSA-C22.2 No.61010-1-12; CAN/CSA-C22.2 No. 61010-2-030-12
l USA: ANSI/UL Std. No. 61010-1:2012; ANSI/UL Std No.61010-2-030:2012
EMC compliance
l IEC61326-1:2012 / EN 61326-1:2013
l Canada: ICES/NMB-001:2006
l Australia/New Zealand: AS/NZS CISPR 11:2011
l South Korea RRA Notice 2016-24
Environmental Conditions
Keysight DAQ970A is designed for indoor use and in an area with low condensation. Table below shows the
general environmental requirements for this instrument.
Environmental condition Requirement
Temperature
Operating condition: 0 °C to 55 °C
Storage condition: –40 °C to 70 °C
Humidity
Operating condition: Up to 80% RH at 40 °C (non-condensing), decreasing linearly to
50% RH at 55 °C (non-condensing)
Storage condition: Up to 50% RH at 55 °C (non-condensing)
Altitude Up to 3000 m
Pollution degree
2
Safety and Regulatory Information
14 Keysight DAQ970A User's Guide

Keysight DAQ970A Specifications

General

Scan Rate	Up to 450 channels/sec
Connectivity	USB, LAN, GPIB (optional)
Display	4.3-inch color LCD
Operating Temperature	0 °C to 50 °C
Number of slots	3 slots
Measurement Types	DCV, ACV, DCI, ACI, 2-wire resistance, 4-wire resistance, frequency, temperature, capacitance
Voltmeter	6.5 digit
Resolution	22 bits
Memory	Non-volatile memory