Keysight DAQ970A User Guide

[Scan] Key
Press the [Scan] key on the front panel to initiate or stop a scan, or to perform a single sweep when manual
trigger mode is selected.
Press [Scan] once to initiate a scan.
The instrument automatically scans the configured channels in consecutive order from slot 1 through slot
3. Channels that are not in the scan list are skipped during the sweep. The [Scan] key's backlight is turned
on while scanning is in progress.
Press and hold [Scan] for more than 2 seconds to stop the scan. "Scan stopped" is shown when the scan-
ning is terminated.
Press [Module] > Scan List to view the available channels on the module that are included in the scan list.
See [Module] Menu for more information on the Scan List softkey. See the [Channel] Menu for more
information on how to include a channel in the scan list (using the InScan softkey). Also, see the
[Interval]Menu for more information on how the [Scan] key is used when the manual trigger mode is selec-
ted.
Keysight DAQ970A User's Guide 69
3 Features and Functions

Keysight DAQ970A Specifications

General

Scan Rate	Up to 450 channels/sec
Connectivity	USB, LAN, GPIB (optional)
Display	4.3-inch color LCD
Operating Temperature	0 °C to 50 °C
Number of slots	3 slots
Measurement Types	DCV, ACV, DCI, ACI, 2-wire resistance, 4-wire resistance, frequency, temperature, capacitance
Voltmeter	6.5 digit
Resolution	22 bits
Memory	Non-volatile memory