EasyManuals Logo

Keysight DAQ970A User Guide

Keysight DAQ970A
232 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #96 background imageLoading...
Page #96 background image
Strain
This section describes how to configure the selected channel for strain measurements from the front panel.
When a force is applied to a body, the body deforms. The deformation per unit length is called strain (ε).
Strain may be either tensile (+) or compressive (-).
The DAQ970A supports two types of strain measurements:
Bridge configuration
Direct resistive method
Once you have configured strain measurement function in all strain channels, press [Home] > Strain Offset
to measure or specify the unstrained offset that will be subtracted from strain measurements before the
strain conversion is performed.
Strain offset
Bridge Configuration
Full and half bridge in bending arrangement
Full and half bridge in Poisson arrangement
Full bridge in bending Poisson arrangement
Quarter bridge arrangement
Full and half bridge in bending arrangement
This section describes how to configure the selected channel for full and half bending bridge strain gage
measurements from the front panel.
1.
Connect bridge configuration source to the module's screw terminals.
Full bending bridge:
Half bending bridge:
[Channel] Menu Overview
96 Keysight DAQ970A User's Guide

Table of Contents

Other manuals for Keysight DAQ970A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Keysight DAQ970A and is the answer not in the manual?

Keysight DAQ970A Specifications

General IconGeneral
Scan RateUp to 450 channels/sec
ConnectivityUSB, LAN, GPIB (optional)
Display4.3-inch color LCD
Operating Temperature0 °C to 50 °C
Number of slots3 slots
Measurement TypesDCV, ACV, DCI, ACI, 2-wire resistance, 4-wire resistance, frequency, temperature, capacitance
Voltmeter6.5 digit
Resolution22 bits
MemoryNon-volatile memory