a. Remove the two screws that secure the riser card to the cage.
b.
Remove the riser card.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the front riser card and PCIe adapter
Follow the instructions in this section to install the front riser card and PCIe adapter.
About this task
Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 75.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
Procedure
Step 1. Install the front riser cards to both cages.
Figure 108. Installing the riser card to low-profile cage
Chapter 5. Hardware replacement procedures 115
To Next Page
Loading...
