Lenovo ThinkSystem SR630 V4 - Page 174

1. Align the triangular mark on the cold plate assembly label with the triangular mark on the
processor carrier and processor.
2. Install the NeptCore module onto the processor-carrier.
3. Press the carrier into place until the clips at all four corners engage.
Note: If the server only has one processor installed, generally processor 1, it is required to install a
cover to the empty socket of processor 2 before proceeding with further installation.
Figure 160. Install the processor socket cover
Step 4. Install the processor-NeptCore module to the system board assembly.
Figure 161. Installing the NeptCore module
1.
Rotate the anti-tilt wire bails inward.
2.
Align the triangular mark and four Torx T30 nuts on the cold plate assembly with the
triangular mark and threaded posts of the processor socket; then, insert the cold plate
assembly into the processor socket.
164
ThinkSystem SR630 V4 User Guide