Figure 176. Removing the manifold
a. Hold the manifold with both hands, and lift it upward to relocate the spools from the small
openings to large ones on the rack cabinet.
b.
Remove the manifold with the connection set attached.
Step 7. Repeat
Step 6 on page 172 to the supply manifold.
Notes:
• There is remaining liquid inside the manifold and the connection set. Remove both together and
leave the further draining to the next step.
• For more information about the rack cabinet, see
ThinkSystem Heavy Duty Full Depth Rack
Cabinets User Guide
.
Step 8. Install the bleeder kit to the manifold supply side.
Note: This step drains the liquid with the help of a pressure difference inside and outside the
supply manifold.
Chapter 5. Hardware replacement procedures 173
To Next Page
Loading...
