Lenovo ThinkSystem SR630 V4 - Page 192

Note: Install the supply side first, then install the return side.
Figure 185. Installing the connection set
1 17 mm wrench
a.
Connect the connection set to both manifolds.
b.
Wrap the interface around with the clamp.
c.
Close the clamp.
d.
Lift the screw upright.
e.
Tighten the screw and make sure that it is secured.
Step 9. Install the connection set to ball valves.
Note: Install the supply side first, then install the return side.
182
ThinkSystem SR630 V4 User Guide