Figure 183. Separating ball valves
1 17 mm wrench
a.
Loosen the screw that locks the ferrule.
b.
Put the screw down.
c.
Open the clamp.
d.
Remove the ferrule.
e.
Remove the ball valve from connection set.
Step 7. Install ball valves to CDU.
Figure 184. Installing ball valves
a. Connect the ball valves to Supply and Return ports.
b.
Wrap the interface around with the clamp.
c.
Close the clamp.
d.
Lift the screw upright.
e.
Tighten the screw and make sure that it is secured.
Step 8. Install the connection set to manifolds.
Chapter 5. Hardware replacement procedures 181
To Next Page
Loading...
