Figure 202. Opening the bleeder valve
Step 10. Separate the manifold from the hose kit in a dry and clean work area, and keep a bucket and
absorbent cloths around to collect any liquid that may drain out.
Figure 203. Separating the manifold from the hose kit
1 17 mm wrench
a.
Loosen the screw that locks the ferrule.
b.
Put the screw down.
c.
Open the clamp.
d.
Remove the ferrule and hose kit from the manifold.
Step 11. Repeat
Step 10 on page 197 to the other manifold.
Step 12. For better sanitation, keep the manifold ports and hose kits dry and clean. Re-install quick connect
plug covers or any covers that protect hose kits and manifold ports.
Step 13. To remove the server from the rack, see
“Remove the server from the rack (friction rails)” on page
82 and “Remove the server from the rack (slide rails)” on page 89.
Chapter 5. Hardware replacement procedures 197
To Next Page
Loading...
