Lenze I/O system 1000 - Page 434

Lenze · I/O system 1000 · Reference Manual · DMS 5.0 EN · 09/2016 · TD17 434
8 DeviceNet communication
8.5 Parameterising the counter
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Further information:Product description
( 15)
Process alarm The activation of a process alarm can be parameterised. A process alarm can be
triggered in the case of the following events:
•Open hardware gate
•Closed hardware gate
• Counter limit overflow
• Counter limit underflow
• Comparison value reached
• Final value reached
• Latch value reached
Diagnosealarm If the diagnostic alarm is enabled in the parameter setting, it occurs if another
process alarm is triggered for the same event during a process alarm processing.
Diagnostic function Diagnostic functions are provided by the modules.
Diagnostic information The diagnostic information describes the diagnostic contents that can be read out of
a module. Diagnostic information is not automatically sent by the module but must
be read out actively via SDO access.
Additional functions Description