Lenze I/O system 1000 - Page 57

4 Configuring the I/O system in the »PLC Designer«
4.3 Mapping the real station structure in the »PLC Designer«
57
Lenze · I/O system 1000 · Reference Manual · DMS 5.0 EN · 09/2016 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
 How to map the station layout of the »PLC Designer«:
Adding the EtherCAT master
1. Go to the context menu of the Controller and execute the Add device... command:
2. Select the "EtherCAT master" device in the Add Device dialog box:
3. Click Add Device to add the selected device to the Controller.
•The Add Device dialog box remains open.
Adding the EtherCAT bus coupler module (slave) to the EtherCAT master
4. Select the "EtherCAT_Master" device in the device view:
5. Now select the "EPM-S130" device (EtherCAT bus coupler module) in the still open Add
Device dialog box.
6. Click the Add Device button to add the selected device to the EtherCAT master.
•The Add Device dialog box remains open.