Lenze · I/O system 1000 · Reference Manual · DMS 5.0 EN · 09/2016 · TD17 70
4 Configuring the I/O system in the »PLC Designer«
4.3 Mapping the real station structure in the »PLC Designer«
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
14. Go to the Select element from the object directory dialog box and select the "Counter Control
Word" with the subindex 1 (":16#01") (this serves to start the counter later):
15. Click on the OK button to accept the selection and close the dialog box again
Configuring the Send PDO Mapping
16. Execute the "Send PDO Mapping" the same way the "Receive PDO Mapping" has been
executed before.
Please observe the following:
• Select "cyclic – synchronous (type 1-240)" as transmission type.
• Go to the Select element from the object directory dialog box and select the "Counter
Value" with the subindex 1 (":16#01"):
To Next Page
Loading...