Lenze i410 - Page 298

25505 0x63A1 CU: load error ID tag Keypad display: CU ID t
ag error
Cause Remedy Error type/response
Calibraon data of the control unit not
compable or faulty.
•
Upda
te
rmware of the inverter to the most
recent version.
•
If the error persists, the control unit or the
device has to be replaced. In this case, please
contact the manufacturer.
Fault
•
The inverter is disabled immediately. The
motor has no torque (coasts).
•
The error can only be reset by mains
switching.
25506 0x63A2 PU: load error ID tag Keypad display: PU ID t
ag error
Cause Remedy Error type/response
Calibraon data of the power unit not
compable or faulty.
•
Upda
te rmware of the inverter to the most
r
ecent version.
•
If the error persists, the power unit or the
device has to be replaced. In this case, please
contact the manufacturer.
Fault
•
The inverter is disabled immediately. The
motor has no torque (coasts).
•
The error can only be reset by mains
switching.
25507 0x63A3 Power unit unknown Keypad display: PU unkno
wn
Cause Remedy Error type/response
The power unit installed is not supported by the
soware.
Update
rmware of the inverter to the most
recent version.
Fault
•
The inverter is disabled immediately. The
motor has no torque (coasts).
•
The error can only be reset by mains
switching.
28800 0x7080 Asseron level monitoring (Low/High) Keypad display: Asseronlevel
Cause Remedy Error type/response
Error message is not available for the inverter
i410.
The las
t seng of the connecon level diers
from the saved seng.
1.
Check seng in .
2.
Ex
ecute device command "Save user data"
0x2022:003 (P700.03).
3.
Switch inverter o and on again.
Fault
28801 0x7081 Analog input 1 fault Keypad display: AI1 f
ault
Cause Remedy Error type/response
The monitoring funcon of the input signal
congured for analog input 1 in 0x2636:008
(P430.08) and 0x2636:009
(P430.09) has been
triggered.
•
Check input signal a
t analog input 1.
•
Check conguraon of the monitoring
funcon.
Fault (congurable)
Seng parameters: 0x2636:010
(P430.10)
Related topics
4Analog input 1 ^ 205
28802 0x7082 Analog input 2 fault Keypad display: AI2 f
ault
Cause Remedy Error type/response
The monitoring funcon of the input signal
congured for analog input 2 in 0x2637:008
(P431.08) and 0x2637:009
(P431.09) has been
triggered.
•
Check input signal a
t analog input 2.
•
Check conguraon of the monitoring
funcon.
Fault (congurable)
Seng parameters: 0x2637:010
(P431.10)
Related topics
4Analog input 2 ^ 209
Diagnoscs and fault eliminaon
Error codes, causes and remedies
298