Error code Description Action
200.09 Printhead did not receive proper motor feedback to
start laser servo.
Go to “Sensor (input) image jam service check” on
page 55.
200.10 Printhead motor not locked when media reaches the
input sensor.
200.11 Printhead motor fell out of lock after page reaches the
input sensor.
200.12 Printhead was not ready for media.
200.13 Media at input sensor is not the next media to be
imaged.
200.14 Media reached the input sensor before EP was ready.
200.15 Image data did not start on time.
200.16 Fuser motor stalled. Go to “Main drive motor control jam service check”
on page 55.
200.19 Page that was successfully picked from option tray
never reached the input sensor.
Go to “Sensor (input) early/late arriving service
check” on page 53.
200.21 No response from paper port driver while waiting for
the source to deactivate the Input Source Ready flag
to indicate it has initiated picking.
200.23 Laser servo never started due to potential conflict
with the transfer servo.
Go to “Sensor (input) image jam service check” on
page 55.
200.24 Measured gap at input sensor too small to meet video
delivery requirements. (Not enough time since prior
image finished to start new image).
200.29 Printhead drive control out of range due to an
external event beyond what the control is designed
to handle.
200.30 Invalid printhead NVRAM.
200.31 Paper, in the middle of a job, at input sensor before
interrupt occurred.
Go to “Sensor (input) early/late arriving service
check” on page 53.
200.32 Detected cover switch bounce.
200.33 Input sensor covered too quickly.
200.38 Interpage servo gap smaller than expected for galvo
offset target evaluation.
Go to “Sensor (input) early/late arriving service
check” on page 53.
200.42 Rogue sheet at ACM sensor while flushing the paper
path prior to declaring tray 1 source empty.
200.44 Page from tray 1 did not reach the input sensor (or
the manual feed sensor, if present) after multiple pick
attempts. Page did make it out of the tray at least as
far as the ACM sensor.
200.45 During warm up flush, sheet detected too long over
input sensor.
4514-420, -430
Diagnostic information
52
To Next Page
Loading...
Need help?
General
